Transferring Scene Files Between The Camera And A Memory Stick (With The Dxc-D50 Series) - Sony CCU-TX50 Operating Instructions Manual

File Operations
Transferring Scene Files between
the camera and a Memory Stick
(with the DXC-D50 Series)
When a DXC-D50-series camera is connected, the
registered scene files can be stored as a data block and
can be read when required.
Storing the scene files on a Memory Stick
Proceed as follows:
1
Insert the Memory Stick (
2
Press the OTHERS button in the Menu operation
block so that the OTHERS menu is displayed on
[RCP Config]
the LCD, then press
Config menu.
3
Set the menu to Advanced Setting mode.
[Security]
1) Press
on the RCP Config menu.
2) Press and highlight
[Status] [Menu Set]
The ,
buttons are displayed.
[Status]
3) Press
.
The Security Status menu appears.
[Advance Mode]
4) Press
4
Return to the OTHERS menu, and press
5
[File Trans]
Press .
The Scene File Transfer display appears.
6
[CAM -> MS]
Press .
A confirmation display appears.
7
[Start]
Press .
The registered scene files are transferred to the
Memory Stick.
When the transfer is finished
The termination message "COMPLETED" appears.
100
).
see page 105
to call the RCP
[Engineer Mode]
.
[Code No.]
, and
.
[File]
.
Reading the scene files from a Memory
Stick
Proceed as follows:
1
Insert the Memory Stick (
2
Operate in the same manner as when you stored
the files until the Scene File Transfer display
appears.
3
[MS -> CAM]
Press .
A confirmation display appears.
4
[Start]
Press .
The scene files are transferred from the Memory Stick
to the connected camera.
When the transfer is finished
The termination message "COMPLETED" appears.
).
see page 105