Sony CCU-TX50 Operating Instructions Manual page 163

OTHERS menu (with the DXC-D50 series)
Menu 2ndary menu Submenu
Adjusting White Shading
Camera Camera ID
Config
Center Marker
Screen Mode
Diag
Bars
File Scene Trans
Copy to Slave
RCP Config RCP
Adjusting
RE Setting
VR Setting
The item "Screen Mode" is displayed when Screen Md Enable is set to ON with Security of RCP Config on the OTHERS menu.
Control item
• R
• G
• B
CAM ID IND
Clock IND
• Char
• Cur
ID SET
Center Marker
Safety Zone
Screen Mode
Req
Reset
• Sel
Bars Type
CAM->MS
MS->CAM
Buzzer • Call
Volume • Touch
• Switch
• Master
Call Buzzer
Touch Click
SW Click
All Off
LED Bright • Switch
• Tally
• Other
• Master
BLACK/FLARE
VR STD Mode
VR Rel. Scale IRIS VR To select the response rate of the IRIS knob (relative-value
Function
To adjust the V white shading (vertical variation of the white) of the
R signal
To adjust the V white shading of the G signal
To adjust the V white shading of the B signal
To turn the camera ID display ON/OFF while the camera is in Color
Bars mode
Switching of the clock indication
Cam: To always display the clock indication
Bars: To display only when the camera color bars are displayed
Off: No clock indication
To select characters when entering a camera ID (alphanumerics,
symbols, and space)
To move the cursor when entering a camera ID (eight characters)
To register the entered camera ID
To turn the center marker ON/OFF
To set the safety zone (90%/80%/OFF)
To select the Screen mode (4:3/16:9)
To request camera's self-diagnostic data (available only when any
abnormality has been detected during self-diagnosis)
To erase the camera's self-diagnostic data
To display the data read from the camera in order (No display when
no abnormality has been detected during self-diagnosis)
To select the type of color-bar signals:
SMPTE(SPLIT)/SNG/FF 75%/FF 100%
To transfer a scene file (from the camera to the Memory Stick)
To transfer a scene file (from the Memory Stick to the camera)
To copy the status of the master unit to slave units
To set the volume of the call buzzer
To set the responding sound volume of the touch panel
To set the confirmation sound volume of the self-illuminating
switches
To set the total buzzer sound volume
To turn the call buzzer ON/OFF
To turn the responding sound of the touch panel ON/OFF
To turn the confirmation sound of switches ON/OFF
To turn the volume of all the buzzers ON/OFF
To set the brightness of respective LEDs
To set the brightness of the all LEDs of the unit
To select the function for the BLACK/FLARE knob
Black: Black balance adjustment
Flare: Flare balance adjustment
To select the initial settings for IRIS or MASTER BLACK
adjustment mode: Absolute or Relative
adjustment rates: 1/1, 1/2, and 1/4, where 1/1 is the quickest
response position)
77