Power Supply; Using Battery Packs - Sony CCU-TX50 Operating Instructions Manual

Camera control unit
Hide thumbs Also See for CCU-TX50:
Table of Contents

Advertisement

Power Supply

This unit operates on either a battery pack or an AC
supply (using the optional CMA-8A/8ACE AC
Adaptor).
For details of the power supplies which can be used, refer to
the documentation supplied with the VTR connected to this
unit or the camera adaptor.
Using an Anton Bauer Intelligent Battery
System and Ultralight System
Fitting the special battery mount made by Anton Bauer
Corporation to this unit allows you to use their
Intelligent Battery System and Ultralight System.
For details, consult your Anton Bauer products supplier or
Sony dealer.
38
Chapter 2 Fitting and Connections

Using Battery Packs

Always fully charge a battery pack before using it.
Notes
• Be careful that other metal objects do not come in
contact with the metal parts of the battery pack, as
this could cause a short.
• Do not leave the battery pack in the camera if it is not
going to be used for a long time.
• If the battery pack is recharged after use while still
hot, it may not be possible to obtain a full charge.
Battery pack operating times
The following table shows approximate continuous
operating times, when operating the camera and 1.5-
type viewfinder at normal temperatures, with a camera
adaptor and the DSR-1/1P or PVV-3/3P connected.
Battery pack
Continuous operating time
NP-1B
a)
about 55 minutes
b)
BP-90A
about 115 minutes
c)
BP-L40A
about 70 minutes
c)
BP-M50
about 90 minutes
BP-IL75
c)
about 140 minutes
BP-M100
c)
about 200 minutes
c)
BP-GL65
about 120 minutes
c)
BP-GL95
about 200 minutes
a) Requires the dedicated DC-L1 Battery Case when the
DSR-1/1P is attached.
b) Requires the dedicated DL-L90 Battery Case when the
DSR-1/1P is attached, or the dedicated DC-500 Battery
Case when the PVV-3/3P is attached.
c) Requires the dedicated BKW-L601 Battery Case when
the PVV-3/3P is attached.
Battery low indications
When the voltage of the supply to the camera head
lowers to or below 11.0 V, LOW BATT appears in the
viewfinder. At this time, the BATT indicator in the
viewfinder flashes when operating with the DSR-1/1P
or PVV-3/3P.
If you continue using the camera head, the BATT
indicator lights up.
When the battery pack is low, replace it with a fully-
charged battery pack.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dxc-d50Ca-tx50Rcp-d50Ccu-tx50p

Table of Contents