Roland VersaStudio BN-20 Master Manual page 31


Enter values in the [Cut Force], [Cut Speed], and [Cut Times] boxes.
Cut Force
Force at cutting time. If this force is too strong, the blade cuts into the backing paper. (Default setting:
50 gf )
Cut Speed
Cutting speed. If the speed is too fast, the cut line is crooked. (Default setting: 15 cm/sec)
Cut Times
The number of times to cut the same location. If it is impossible to cut even if you adjust the cut force
and cut speed, increase the cut times. (Default setting: 1)
Assessment of cutting test results
Check the cut shapes.
The cut shape is crooked  Decrease the value of [Cut Speed].
Peel off the circle.
The square also peels off  Increase the value of [Cut Force].
Some uncut areas remain  Decrease the value of [Cut Speed].
Peel off the square.
There is a faint blade mark on the backing paper  Do not change the value of [Cut Force].
The blade mark is indistinct  Increase the value of [Cut Force].
The blade mark is too deep and the backing paper is also cut  Decrease the value of [Cut Force].


Click [Finish].
Circle
Click [Apply].

Repeat
Chapter 2 Fully Utilizing the Machine
Cutting / Printing & Cutting
Square

and until correctly adjusted.
29