Printing; Step 1: Loading Media - Roland VersaStudio BN-20 Master Manual

Printing

This section describes operations when printing only. Refer to page 28 "Cutting / Printing & Cutting" and page
35 "Performing Printing and Cutting Separately."

STEP 1: Loading Media

Roll media
Procedure

Push the loading lever backward.
Move the left media guide to the left.

Hole
Media flange

Load the roll media onto the media bar.
Press the media flanges into the paper tube at both ends. Place the fixed media flange at the bottom, so
that the media feeds in a clockwise direction when looking from above. You cannot set the media cor-
rectly if the feed direction is not correct.
14
Chapter 1 The Basics
Loading lever
Left media guide
Media bar
Mounting pin
Push in
Attach the media flange to one end of
the media bar.
Insert the side of the media bar with a hole into
the media flange, and secure it with the mounting
pin. Use one of the two media flanges. The inside
should be the one that fits the inner diameter of
the roll media paper tube.
Push in
Make sure that there are no gaps.