Cautionary Note On Making Output With Cutting - Roland VersaStudio BN-20 Master Manual

Cutting / Printing & Cutting

Specify the RGB value set for the part to be identified as the cutting line in step

.
If the color for the part you want to print and the color set in procedure
tings from step

Specify the line width for cutting lines as follows.
Adobe Illustrator CS5/CS4/CS3: 0.001 pt
CorelDRAW X5/X4/X3: Hairline
It may not be possible to cut lines of the specified width.

Cautionary note on making output with cutting

Points to Note when Cutting Only
For roll media, let the media hang down to the rear before outputting.
When using the roll media and only performing cutting, let the media hang down to the rear of the machine.
This prevents a motor error or fall of the media caused by the media being pulled with excessive force.
Do not cut the media before it is taken back if "Take back after printing" is specified in
the BN-20 driver.
Do not cut the media before it is taken back when "Return to home position after printing" is ON in the "Printer
Control" tab of the BN-20 driver. If the media is cut before it is taken back, ink might be ejected to a location
where there is no media.
When a check is put
here, the media is taken
back after printing.
In the case of print & cut, dry the ink sufficiently before cutting.
You can set time for the printer to wait before cutting (Dry Time) with the R-Works, BN-20 driver, or Roland
VersaWorks. The dry time varies according to the media.
 P. 63, "Setting of Dry Time"
34
Chapter 2 Fully Utilizing the Machine
1.

- .
1.

- overlap, redo the set-
1.
-