Basic Operation; Power Sources; Side Handle - Red Epic EPIC-M Operation Manual

RED EPIC OPERATION GUIDE
NOTE: The RED LCD swivel axis has a total range of adjustment of approximately 360˚ (180˚ clockwise or
counterclockwise from the nominal "rear-facing" display orientation). The range of adjustment for the tilt axis
is approximately 180˚. At the end of the adjustment range are internal "hard stops" for both axes. Once the
swivel or tilt hard stops have been reached, IMMEDIATELY STOP APPLYING FORCE TO THE LCD.
Continuing to apply force after reaching the internal stops may damage the friction hinge. Damage to the
RED LCD or other components of the DSMC system caused by using excessive force to rotate the RED LCD
is not covered under warranty.

BASIC OPERATION

This section describes basic operation, starting from power up, Viewfinder layout and Menu navigation.
WARNING: The Side Handle, Side SSD Module, rear modules and Lens Mount are NOT HOT SWAPPABLE –
meaning you cannot remove or install them while the camera is powered on. Before installing or removing
any of these accessories, you MUST power down the camera. Failure to do so may result in damage to the
accessory and / or camera brain that will not be covered under warranty.
Power draw is prioritized as follows when multiple power sources are available to the camera.
1. DC (Voltage) or Brick (%)
2. Battery Module batteries
3. Side Handle battery

POWER SOURCES

SIDE HANDLE

The optional Side Handle accepts one REDVOLT.
Side Handle Battery Compartment
COPYRIGHT © 2013 RED.COM, INC 955-0002_v4.0, REV-C | 40