Basic Operation; Power Sources; Side Handle; External Dc Power - Red Epic Epic-M Operation Manual

BASIC OPERATION

This section describes basic operation, starting from power up, Viewfinder layout and Menu navigation.
WARNING: THE SIDE HANDLE, SIDE SSD MODULE, REAR MODULES AND LENS MOUNT ARE NOT
HOT SWAPPABLE – MEANING YOU CANNOT REMOVE OR INSTALL THEM WHILE THE CAMERA IS
POWERED ON. BEFORE INSTALLING OR REMOVING ANY OF THESE ACCESSORIES, YOU MUST
POWER DOWN THE CAMERA. FAILURE TO DO SO MAY RESULT IN DAMAGE TO THE
ACCESSORY AND / OR CAMERA BRAIN THAT WILL NOT BE COVERED UNDER WARRANTY.

POWER SOURCES

SIDE HANDLE

The optional Side Handle accepts one 30Wh REDVOLT® battery, which can power the camera and
typical accessories for approximately 30 minutes when recording in 24 fps RAW 5K MOVIE mode.

EXTERNAL DC POWER

EPIC accepts input voltages between 11.5V - 17V D.C and can draw a maximum current of 12 Amps.
•
An appropriate 150W supply with DC output rated at 15V 10A such as AC Power Adapter P/N 740-
0019 available from RED DIGITAL CINEMA.
• RED Charger. For RED Charger you must use 2B-to-1B Power Adapter Cable P/N 790-0138.
Version 1.7.10
NOVEMBER 17, 2011
Figure 15: Side Handle Battery Compartment
©2011 RED.COM INC.
31