External Dc Power; Power Up - Red Epic EPIC-M Operation Manual

RED EPIC OPERATION GUIDE

EXTERNAL DC POWER

RED DSMC Cameras accept input voltages between 11.5V - 17V D.C and can draw a maximum current of 12
Amps.
An appropriate 150W supply with DC output rated at 15V 10A such as AC Power Adapter P/N 740-0019

available from RED DIGITAL CINEMA.
RED Charger. For RED Charger you must use 2B-to-1B Power Adapter Cable P/N 790-0138.

RED BRICK ® 140Wh batteries may be used with Backpack Quickplate, RED Quickplate, Battery Belt Clip,

or RED Cradle via 2B-to-1B Power Adapter Cable P/N 790-0138.
4-pin XLR DC power sources may be used with the camera via adaptor cable P/N 790-0164.


POWER UP

Locate the camera's Power / Record button on the right face of the Brain.
NOTE: This button also serves as a Record Start / Stop button once the camera is powered up.
A
C
When an appropriate power source is connected to the Brain, the Power Status LED will illuminate Red. If it
is illuminated, depress and then release the Power / Record button. The Power Status LED will initially go
out and within 5 seconds illuminate Orange to confirm the camera is powering up, then it will illuminate
Green, confirming the camera is powered up and ready to use.
If a formatted REDMAG 1.8" SSD is attached to the Brain, once powered up the Media Status LED will
illuminate Green. If this LED is not illuminated, verify a formatted REDMAG 1.8" SSD is inserted into the Side
SSD Module and / or format the SSD if it has not previously been formatted on the camera.
COPYRIGHT © 2013 RED.COM, INC
B
EPIC BRAIN
A. Power Status LED
B. Power/Record Button
C. Record Status LED
955-0002_v4.0, REV-C | 47