Dc In (Power Input) - Red Epic EPIC-M Operation Manual

RED EPIC OPERATION GUIDE
DC IN (PO WER INPUT)
The 6-pin LEMO connector accepts DC input power between +11.5 V and +17 V DC. Power conditioning
provides protection against reverse-polarity connection, ESD, under and over voltage, and over current.
PIN SIGNAL
1
+VBATT
2
3 SCL-BATT
4
GROUND
5
6 SCA-BATT
WARNING: It is very important that both pairs of +VBATT and GROUND pins are wired up. DO NOT
fabricate power cables with just one each of +VBATT and GROUND pins wired, as this may cause damage to
the camera's power supply; this is not covered by Warranty.
NOTE: Two pre-fabricated DC Power input cables are available from RED Digital Cinema.
P/N 790-0138 – DC Power – REDBRICK

P/N 790-0164 – DC Power – XLR to Camera – 10 ft. (3m)

COPYRIGHT © 2013 RED.COM, INC
View into DC IN Power Input Connector
Mating Connector: LEMO FGJ.1B.306.CWLD72Z
DESCRIPTION
Power input, +11.5 to +17 V DC
Serial Battery Bus Clock
Power Return (Camera Ground)
Serial Battery Bus Data
® QUICKPLATE to Camera – 18 in. (0.5m)
955-0002_v4.0, REV-C | 184