Eject Media From Camera; Media Capacity Remaining Status - Red Epic EPIC-M Operation Manual

RED EPIC OPERATION GUIDE

MEDIA CAPACITY REMAINING STATUS

The Viewfinder output(s) will display the remaining media capacity in the MEDIA indicator (100% is shown).
At 10%, remaining capacity the media status will turn yellow, at 5% it will turn red. At 2%, remaining the
camera will cease recording. This reserves a small amount of capacity for ancillary data to be written to the
media.
NOTE: When media is full, the Side SSD LED will flash Red.
EJECT MEDIA FROM CAMERA (UNMOUNT)
IMPORTANT: Media must always be Ejected (un-mounted) prior to removal or disconnection from the
camera. This ensures power is removed from the digital media and any open data files are closed. Failure to
do so may result in lost data or corrupted files.
Removing an SSD without first un-mounting it will not physically damage the media, however it does
increase the risk of file corruption, so it's good operational practice to un-mount the media if possible before
removing or disconnecting.
IMPORTANT: Unmounting the digital media takes a few seconds, protects the integrity of your recorded
data and helps clips mount instantly to your workstation once in post-production, so it's a recommended
habit to develop. If you do not un-mount the media the camera will offer a warning – your files may not be
damaged, but you will have been warned!
NOTE: The camera will respond to physical removal of the media without un-mounting and display "MEDIA
REMOVED PRIOR TO UNMOUNT – DATA INTEGRITY RISK".
COPYRIGHT © 2013 RED.COM, INC 955-0002_v4.0, REV-C | 172