DC IN (POWER INPUT)
The 6-pin LEMO connector accepts DC input power between +11.5 V and +17 V DC. Power
conditioning provides protection against reverse-polarity connection, ESD, under and over voltage, and
over current.
PIN
1
2
3
4
5
6
WARNING: It is very important that both pairs of +VBATT and GROUND pins are wired up. DO
NOT fabricate power cables with just one each of +VBATT and GROUND pins wired, as this may
cause damage to the camera's power supply; this is not covered by Warranty.
NOTE: Two pre-fabricated DC Power input cables are available from RED Digital Cinema.
•
P/N 790-0138 – DC Power – REDBRICK
•
P/N 790-0164 – DC Power – XLR to Camera – 10 ft. (3m)
955-0002_v3.3, Rev-B
View into camera DC IN Power Input connector
Mating Connector:
LEMO FGJ.1B.306.CWLD72Z
SIGNAL
+VBATT
Power input, +11.5 to +17 V DC
SCL-BATT
GROUND
Power Return (Camera Ground)
SCA-BATT
QUICKPLATE to Camera – 18 in. (0.5m)
®
COPYRIGHT © 2012 RED.cm, Inc.
DESCRIPTION
Serial Battery Bus Clock
Serial Battery Bus Data
175
175