Dc In (Power Input) - Red Epic Epic-M Operation Manual

DC IN (POWER INPUT)

The 6-pin LEMO connector accepts a DC voltage between +11.5V and +17V DC. Power conditioning
circuits provide protection against reverse-polarity connection, ESD, under voltage, and over current.
PIN
1
2
3
4
5
6
WARNING: It is very important that both pairs of +VBATT and GROUND pins are wired up. DO NOT
fabricate power cables with just one each of +VBATT and GROUND pins wired, as this may cause
damage to the camera's power supply; this is not covered by Warranty.
NOTE: Two pre-fabricated DC Power input cables are available from RED Digital Cinema.
• P/N 790-0138 – DC Power – REDBRICK® to Camera – 18 in. (0.5m)
•
P/N 790-0164 – DC Power – XLR to Camera – 10 ft. (3m)
152 152
Figure 25: View into camera DC IN Power Input connector
Mating Connector:
SIGNAL
+VBATT
SCL-BATT
GROUND
SCA-BATT
©2011 RED.COM INC.
LEMO FGJ.1B.306.CWLD72Z
DESCRIPTION
Power input, +11.5 to +17VDC
Serial Battery Bus Clock
Power Return (Camera Ground)
Serial Battery Bus Data
Version 1.7.10
NOVEMBER 17, 2011