Installing The Camera; Wired Connection To A Network - Beward N13103 Installation & User Manual

 Unshielded twisted pair cables should be located at distance of at least 1.5 meters from
electromagnetic interference sources that produce electric field strength exceeding 3
V/m.
 Switchboards with pinned unshielded twisted pair cables should be located at distance
of at least 3 meters from electromagnetic interference sources that produce electric field
strength exceeding 3 V/m.
 Entire twisted pair cables should be arranged between the points of connection so the
cable run is as short as possible.
 Minimum cable bending radius is four times the cable diameter (or 1 inch=2.5 cm) or it is
also acceptable to install the cable so the cable bending radius is 2 inches (5 cm).
 Maximum length of the entire segment is 100 meters.
 When connecting over Wi-Fi, take notice that the signal strength depends on many
factors such as the distance to the access point, electromagnetic waves, configuration of
the place where the camera is installed, etc.

4.3. Installing the Camera

Step 1: attach the bracket to the surface using 3 self-tapping screws.
Step 2: loosen the bracket screws to move the camera to the desired position.
Step 3: attach the camera to the bracket, adjust the tilt angle and fasten the camera.

4.4. Wired Connection to a Network

Step 1: provide power to the camera using the included 12 V 1 A power supply:
Step 2: use the supplied RJ45 cable to connect the camera to a network (a LAN port of the
router).
If needed, you can purchase a network cable separately or if you have the materials, tools
and skills, you can make a network cable.
A straight RJ-45 cable (UTP category 5)
The table below shows an example of a patch cord to connect the camera to a computer or
a network switch.
N13103 Installation User Manual
Chapter 4. Installing the Camera and Connecting a Cable
10