Changing The Local Network Parameters - Beward N13103 Installation & User Manual

Wi-fi, megapixel cmos sensor, 16 channel surveillance software included, built-in multi-zone motion and audio detection
Table of Contents

Advertisement

If you see the following information in the opened window: [DHCP Enabled] – Yes, [IPv4
Address] – xxx.xxx.xxx.xxx (xxx.xxx.xxx.xxx is an IP address value), it means your computer is
assigned an IP address displayed in the [IPv4 Address] line, a subnet mask displayed in the [IPv4
Subnet Mask] line, a gateway address displayed in the [IPv4 Default Gateway] line, a DNS
server address displayed in the [IPv4 DNS Server] line.
Please make a note of the following parameters: IP address, Subnet mask, Default
gateway, DNS server.
IMPORTANT!
If you do not make a note of the network parameters, you will not be able to return the computer's network
settings to their initial state to connect the computer to a local network or the Internet after configuring the
N13103. Therefore, your computer will not have local network and/or Internet access.
IMPORTANT!
If you see the following information in the [Network Connection Details] window: [DHCP Enabled] –
Yes, [IPv4 Address Autoconfiguration] – xxx.xxx.xxx.xxx (xxx.xxx.xxx.xxx is an IP address value), it
means you could not establish a wired connection and the DHCP server did not assign the computer an IP
address. Please check the connection settings or contact your system administrator.

5.2. Changing the Local Network Parameters

The default IP address of the N13103 IP camera is 192.168.0.99. To connect to the
camera, you need to get your computer and your camera on the same subnet. Take notice that
each device must have a unique IP address.
IMPORTANT!
The camera's default IP address is 192.168.0.99. If you use several IP cameras, you need to change their
default IP addresses so that each camera will have a unique IP address to prevent an IP address conflict.
IMPORTANT!
If you are sure that your computer and your IP camera are on the same subnet, you can skip this
paragraph and go to
paragraph
To change your computer network settings, go to Start – Control Panel (Pic. 5.13).
N13103 Installation User Manual
Chapter 5. Setting Up the Wired Connection for Windows 7
5.3.
19

Advertisement

Table of Contents
loading

Table of Contents