Beward N13103 Installation & User Manual page 60

 Enable UPnP on your camera and configure it.
See your router's user manual for details on how to enable and configure the UPnP.
To enable and configure UPnP on your camera, follow the steps below:
Step 1: enable UPnP on your camera. To do so, go to: SETTING – Network – UPnP.
Step 2: check the [Turn On UPnP port forwarding] (Pic. 7.3.).
Step 3: in the [HTTP port] field, enter the HTTP port number that you want to use to
access the camera over the Internet. For example, the value of the port you assigned is 10000. In
this case, port 80 is used to access the camera over a local network and port 10000 is used to
access the camera over the Internet. The default value is 80.
Step 4: in the [RTSP port] field, enter the RTSP port number that you want to use to
access the camera over the Internet.
Step 5: click [OK] to save the changes.
IMPORTANT:
You must reboot the camera for the changes to take effect.
IMPORTANT:
To use port forwarding, the port number values of the camera must match the router port numbers.
To access the camera over the Internet, use the IP address provided by your ISP (IP
address of the router's WAN port) and a certain port number.
N13103 Installation User Manual
Chapter 7. Accessing the Camera over the Internet
Pic. 7.3
59