Wiring Diagram - Sensorsafe Models - Follett Symphony 25CT400A Installation, Operation And Service Manual

How unit works — SensorSAFE models
SensorSAFE models provide "touchless" ice and water dispensing. When a container is placed within the actuation
zone below the ice or water chute on SensorSAFE dispenser models, an infrared signal refl ects off the container and is
detected by the sensor. The sensor then sends a signal to the control board to activate the appropriate components to
dispense ice or water. LEDs on the board indicate when the board is receiving a signal from the sensors.
A safety, shut-off feature automatically shuts off dispensing after one minute of continuous activation. Dispensing can be
restarted by moving the container away and then returning it to the actuation zone.
Dispensing can be temporarily suspended for cleaning by depressing and releasing the clean switch, located under the
left side of the top front cover. Depressing and releasing the button a second time will return the dispenser to normal
operating state. If the clean switch is not depressed a second time, the dispenser will automatically resume normal
dispense operation (CLN LED goes out) after two minutes. An LED on the control board will light to indicate that the
dispensing has been suspended by activation of the clean switch.
dispenser power
switch
4x4 junction box
located behind splash panel
bin signal
t-stat
red
SensorSAFE
control board
green
NEUTRAL
115VAC
60hz
ice machine
power
(120 VAC)
ice machine
bin signal
(120 VAC)
switch
red
wheel motor
purple
yellow
yellow
blue
water solenoid valve
19
white
white
white
white
M
clean
switch
white
WTR
white