Color Calibration Of Printer - Lexmark Optra Color 1200 Service Manual

5050-001
printing the following message is displayed. The Power indicator
also blinks while the page is printing.
The printer will attempt to print the Top Margin page from the default
paper source. However, if the default source only supports
envelopes, then the page will be printed from Tray 1. The page
consists of alignment diamonds. When you change the value for that
tray you will see the CMY alignment diamonds move up and down
the page. The test page also contains the page count setting, printer
serial number, and code levels.
The Test Page can only be printed for the trays that are installed.
The Menus to change the values show up even if the tray is not
installed. This allows the service person to set these values to the
factory values even if a customer does not have that tray installed.
The Test page should be printed on Letter or A4 paper only.
To exit the Registration menu, press Return.

Color Calibration of Printer

Printhead Adjustment - X, Y, and Theta
Test Print Pages
Printing the color calibration pages allows a service person to align
the Cyan, Magenta, and Yellow planes with the Black plane. The
planes must be adjusted in three different directions, the X direction,
the Y direction and the Theta direction. These values must be
adjusted for each plane. View the page in the portrait position when
you check these adjustments.
The X, Y, and Theta adjustment must be checked with the radar test
page found in the X Adjustment menu, (Test Print) sub menu.
3-12
Service Manual
Quick Test
Printing...