Viewing The Error Log - Lexmark Optra Color 1200 Service Manual

5050-001
Press Go for the calibration to begin. The operator panel displays
that it is performing the calibration.
When the engine has completed the Sensor Calibration for paper,
the operator panel returns to the Sensor Calibration menu.
Press Menu> or Menu< to calibrate the sensor for Transparency.
These same steps should be followed for transparencies. The
transparency must be loaded in the MP Feeder.
After the sensor has been calibrated for both paper and
transparencies, the calibration is complete.

Viewing the Error Log

The Error Log aids the Customer Engineer by providing a history of
printer errors. It contains the 12 most recent errors that have
occurred on the printer. The most recent error is displayed in
position 1, and the oldest error is displayed in position 12 (assuming
12 or more errors have occurred). If fewer than 12 errors have
occurred, then the oldest error is displayed in the position before the
empty log entries begin. Empty log entries are identified with an
error number of 000 . Occupied log entries contain the error number
for the message that is displayed on the operator panel. For
example, 925 is contained in the log when a 925 Service Error
occurs.
If an error occurs after the log is full, the oldest error in the log is
discarded to make room for the new error.
The following error messages are stored in the error log:
All 2xx paper jam messages.
All 9xx service messages.
Sensor Cal.
Performing Cal
Sensor Cal
Paper
Diagnostic Aids
3-25