Symptom Table - Lexmark Optra Color 1200 Service Manual

Optra color 1200
Hide thumbs Also See for Optra Color 1200:
Table of Contents

Advertisement

5050-001
Message
88 color Toner
Empty
91 Fan Error
RIP Controller
Board Fan
2 xx Paper Jam /
Open Top Cover

Symptom Table

Symptom
You cannot print color.
Transparencies curl
excessively.
Action
The printer has detected that the specified toner
cartridge is completely out of toner. You must install a
new toner cartridge before you can continue printing.
If this message does not reset after you replace all the
toner cartridges, replace the toner remaining sensor
(11G0207) in the right sub-frame.
1. Be sure connector C193 is properly connected to
the RIP controller card.
2. Replace the fan (11G0606) if necessary.
3. If you still have a problem, replace the RIP controller
card (11G0604).
The printer has detected a paper jam in the area
specified in the message. In some cases, the
message alternates with the
Top Cover
message to remind you to open the top cover and
remove jammed paper from inside the printer.
You must remove all the paper from the entire paper
path. Close the top cover and press Go to clear the
message. If the message does not clear, go to the
"Paper Jam Service Check" on page
Action
Make sure the Color Correction menu item is not
set to Black & White.
Make sure the color print units are completely
installed in the printer.
Make sure the RIP controller card is completely
inserted in the printer and the thumbscrews are
securely tightened.
Go to the
"Transport Belt/BUD Service Check"
on page
2-29.
Make sure you're using the recommended
Lexmark transparencies. Also be sure the paper
delivery is set to the rear exit.
Paper Jam
2-30.
Diagnostic Information
Open
2-23

Advertisement

Table of Contents
loading

Table of Contents