Registration Roller Removal - Lexmark Optra Color 1200 Service Manual

5050-001

Registration Roller Removal

1. Remove the rear cover, the front cover, and the right side cover.
2. Remove the right-front sub-cover.
3. Remove the connector from printer controller board.
4. Remove the lead line from the wire saddle.
5. Remove the registration roll, (4 black screws). Be careful of the
lead line.
6. Remove the registration clutch from the registration roller, (1 E-
ring). l
When you reassemble, put conductive grease on the contact portion
between the shaft of the registration roll unit and registration roller
ground plate.
4-52
Service Manual