Lexmark Optra Color 1200 Service Manual page 107

5050-001
percentage of the testing phase which is complete and the number
of bad blocks which have been found. The Power indicator also
blinks while the testing phase is in progress
The cleaning or testing phase can be cancelled at any time by
pressing Return or Stop. If either phase is cancelled, the following
message is displayed momentarily before returning to the DEVICE
TESTS screen.
Once both phases complete, one of the following screens is
displayed.
If fewer than 2,000 bad blocks are detected, then the following
screen is displayed. This screen indicates the number of bad blocks
( xxxxx ) and usable blocks ( yyyyyy ) on the disk. Press Go, Return,
or Stop to return to the DEVICE TESTS screen.
If more than 2,000 bad blocks are detected, then the following
screen is displayed. This screen indicates the number of bad blocks
(xxxxxx). The disk cannot be recovered because too many bad
blocks exist on the disk. Press Go, Return, or Stop to return to the
DEVICE TESTS screen.
If the bad block count is 6 digits long (i.e. the whole disk is bad), then
the 's' is dropped from "blocks" to make room for the sixth digit.
3-22
Service Manual
Testing Disk...
Bad:000000 00%
Disk Test/Clean
Cancelling...
xxxxx Bad Blocks
yyyyyy Usable
xxxxx Bad Blocks
Replace Disk