Lexmark Optra Color 1200 Service Manual page 45

5050-001
Message or Symptom
Error
965 Emulation Error
Download emulation
outdated. Time stamps
indicate the download
emulation and RIP code are
incompatible.
97X INA Failure
Network Card Error
977
Switch Error
980
Transfer Belt or Belt Up/
Down (BUD) Sensor
Problem
2-6
Service Manual
Action
Contact Technical Support for
assistance.
Be sure the RIP controller riser
card and the INA are properly
installed.
Replace the INA. If you still have a
problem, replace the RIP
controller card (11G0604).
The system processor has
detected an INA is installed but
cannot communicate with it. The X
after the card indicates which one
has the problem. Network card 1
always refers to the INA in the
bottom slot and Network card 2
always refers to the INA in the top
slot.
Be sure the RIP controller card
riser card is properly installed.
1. Be sure connector CN106 is
connected to the printer
controller board.
2. Be sure the BUD sensor
actuator is working properly.
3. Clean the BUD sensor.
4. Firmly connect the connector.
5. Do a sensor test. Check for
approximately +5 V on pin 2 to
GND of connector CN106 as
you actuate the flag in the
sensor. Replace the actuator or
sensor if necessary.
6. Replace the BUD motor unit
(11G0251).
7. If you still have the problem,
replace the printer controller
board (11G0324).