Power Supply Module - Mitsubishi Electric Q173HCPU User Manual

2 SYSTEM CONFIGURATION

2.4.2 Power supply module

Item
Base loading position
Applicable base unit
Input power supply
Input frequency
Input voltage distortion factor
Max. input apparent power
Inrush current
5VDC
Rated output current
24VDC
External output voltage
Overcurrent 5VDC
(Note-1)
protection
24VDC
Overvoltage
5VDC
(Note-2)
protection
Efficiency
Allowable momentary power failure
(Note-3)
time
Dielectric withstand voltage
Insulation resistance
Noise immunity
Operation indication
Fuse
Application
Rated switching
voltage/current
Contact
Minimum switching load
output
Response time
section
Life time
Surge suppressor
Fuse
Terminal screw size
Applicable wire size
Applicable crimping terminal
Applicable tightening torque
Exterior dimensions[mm(inch)]
Mass [kg]
(1) Table of the power supply module specifications
This section describes the power supply modules specifications.
Q61P-A1
100 to 120VAC
(+10%/-15%)
(85 to 132VAC)
Across inputs and outputs (LG and FG separated), across inputs and LG/FG, across outputs and
• By noise simulator of 1,500Vp-p noise voltage, 1 µ s noise width and 25 to 60Hz noise frequency
• Noise voltage IEC61000-4-4, 2kV
ERR contact (contact switched off (opened: normally closed contact) at an error stop of CPU), for
CPU module operating status output
Electrical
Q61P-A2
Power supply module loading slot
Q33B, Q35B, Q38B, Q312B, Q65B, Q68B, Q612B
200 to 240VAC
(+10%/-15%)
(170 to 264VAC)
50/60Hz ±5%
5% or less
105VA
20A 8ms or less
6A
——
——
6.6A or more
——
5.5 to 6.5V
70% or more
20ms or less
Across inputs/LG and outputs/FG
2,830VAC rms / 3 cycles (Altitude : 2000m (6561.68ft.) )
LG/FG 10M or more by insulation resistance tester (500VDC)
LED indication (Normal : ON (Green), Error : OFF)
Built-in (Unchangeable by user)
24VDC, 0.5A
5VDC, 1mA
OFF to ON: 10ms or less. ON to OFF: 12ms or less.
Mechanical : 20 million times or more
: 100 thousand times at rated switching voltage/current or more
M3.5 screw
0.75 to 2mm
RAV1.25 to 3.5, RAV2 to 3.5
0.66 to 0.89 N•m
98(H) × 55.2(W) × 90(D)
(3.86(H) × 2.17(W) × 3.54(D) )
0.31
2 - 29
Q61P
100 to 240VAC (+10%/-15%)
(85 to 264VAC)
130VA
(Note-4)
None
None
2
0.40
Q62P
105VA
3A
0.6A
24VDC±10%
3.3A or more
0.66A or more
65% or more
0.39