Chevrolet 1977 light duty truck Service Manual page 319

Fig. 3D-6 -Shock Absorber-G-10, 20, 30
7. Align lower end o f shock absorber with axle
bracket, and install bolt, washers and nut, as shown.
8. Tighten nuts to specifications.
CAUTION: See C A U T IO N on page 1 o f this
section regarding shock absorber fasteners.
9. If equipped with airlift shock absorbers, inflate
to 10-15 pounds m inim um air pressure.
Fig. 3D-8--Shock Absorber-P30
10. Lower vehicle and remove from hoist.
S TA B ILIZE R SHAFTS
Refer to Fig. 3D-9, 3D-10 and 3D-11 for specific
rear stabilizer shaft m ounting on C and P models.
Replacement
1. Raise vehicle on hoist and support rear axle.
N O TE : Route Parking Brake C a b le