Chevrolet 1977 light duty truck Service Manual page 182

Fig. 2D-126--Remote C ontrol and Latch
in this position while
specifications.
4. Install the trim panel.
REAR DOOR UPPER OR LOWER LATCHES
A N D /O R LATCH RODS
Removal
1. Remove trim panel.
2. Disengage rod from remote control assembly.
See figure 2D-126.
3. Remove latch retain in g screws and withdraw
latch and control rod.
4. Remove spring clip retaining rod to latch.
Installation
1. Install latch rod to latch.
N OTE: W hen reinstalling the lower latch rod to
control, the short straight section attaches to the
latch.
2. Install latch and rod assembly into door and
connect rod to remote control.
3. Install latch retaining screws and torque to
specifications.
to rq u in g the screws to
4. Adjust latch to strikers.
REAR DOOR O UTSIDE HANDLE
Removal
1. Remove trim panel.
2. Remove door handle retaining screws, handle
and gaskets. See figure 2D-127.
Installation
1. Apply grease to remote control where handle
plunger makes contact.
2. Install handle and gaskets. Torque screws to
specifications.
3. Install trim panel.
REAR DOOR LOCK CYLINDER
Removal
1. Remove trim panel.
2. Remove remote control.
3. Remove lock cylinder retainer and lock cylinder.
Installation
1. Install lock cylinder and retainer.
2. Install rem ote control.
specifications.
3. Install trim panel.
REAR DOOR GLASS AND W E A TH ER S TR IP
Removal and installation procedures are the same as
for the stationary body side windows. Refer to those
procedu res for rear doo r
replacement.
REAR DOOR A D J U S T M E N T S
NOTE: Door adjustments are provided by slotted
holes, at hinge attachment, in body and door.
1. Remove or loosen door strikers and wedges.
2. Loosen door hinge bolts and adjust door to
T orq ue screws to
glass and w eath erstrip