H In G E - Chevrolet 1977 light duty truck Service Manual

Fig. 2D 103- Cord Insta lla tion
c. Finish seating
pulling on both ends o f the cord at each corner. This will
insure proper positioning o f the critical upper corners.
DOOR A D J U S T M E N T S
Doors can be adjusted for alignm ent o f clearance in
the cab door opening, and for proper latching. Door
alignm ent adjustments are m ade at the striker bolt, and
at door hinges. The door, when properly located in door
opening, will have equal clearance around its perimeter.
The door should be adjusted in the opening so the edge
strip to body.
w'indow.
washer latch and screw. Torque to specifications.
retaining screws and window.
corners by simultaneously
screws and remove latch.
FRONT DOOR
of the door across the top and also at the lock side is
parallel with the body opening as nearly as possible.
adjustment
to pro per position, and tightening bolts securely. See
figure 2D-106. for typical adjustments.
d. Seal windshield to weatherstrip and w eather­
S W IN G O U T W IN D O W
Removal
1. Swing out the window. See figure 2D-105.
2. Remove screws retaining latch to body.
3. Remove window hinge retaining screws and
4. Remove latch from glass.
Installation
1. Install latch to glass using escutcheon, spacer,
2. Place window into opening and install hinge
3. Install latch to glass.
LATCH S W IN G O U T W IN D O W
Replacement
1. Swing out the window.
2. Remove latch to body and latch to window
3. Reverse above steps for installation.
Hinge Adjustment
D oor hinge bolt holes
possible. Alignment
made by loosening the proper hinge bolts, aligning door
are oversized to make
adjustments can be