Chevrolet 1977 light duty truck Service Manual page 154

Fig. 2D 6 7 -Latches and Rods
Fig. 2D 68 Removing Side Latch
control assembly, then remove screws which secure inside
handle to inner panel.
8. Remove three screws
control assembly to inner panel.
9. Remove control assembly and inside handle as
shown in figure 2D-70.
10. Refer to figure
regulator installation.
11. Roll window to up position.
12. Disconnect sash from regulator as shown in
figure 2D-72.
13. Remove glass from endgate.
14. Remove four regulator attaching screws and
withdraw regulator from endgate as shown in figure 2D-
73.
15. Remove outside handle by removing nuts from
inside o f outer panel. See figure 2D-74.
16. Reverse the above steps for reassembly.
which retain remote
2D-71 for window and
Fig. 2D-70--Removing Control Assembly and Inside
Handle
TAILG ATES (03, 63 and 14)
Replacement
Utility vehicles (14) without removable tops utilize a
tailgate shown in figure 2D-75. C hassis/cab (03 and 63)
models have optional pickup units which utilize tailgates
as shown in figures 2D-75 and 2D-76.
The tailgate shown in figure 2D-75 can be removed
by disconnecting both links from the tailgate, removing
screws attaching both trunnions to body, and lifting the
tailgate off the vehicle.
The tailgate shown in figure 2D-76 can be separated
from the vehicle by removing the bolt and lock washer
from each trunnion in carrier box, and removing the
tailgate.