Chevrolet 1977 light duty truck Service Manual page 111

G e n e ra l D escrip tion .......................................................... 2B-1
Service Procedures - 10 thru 30 Series.................... 2B-1
Fron t Bumper - C, K and P M o dels..................... 2B-1
R ear Bum per - C and K M odels............................. 2B-1
All 1977 truck front and rear bumpers are o f a
single piece design. Bumper
sta n d a rd bracket and brace to fram e mountings. This
SERVICE PROCEDURES—10 THRU 30 SERIES
F R O N T BUM PER-C, K AN D P MODELS
Removal Fig. 2B-1, 2B-2
1. Remove bolts securing two bum per brackets to
frame.
2. Remove bolts securing bum per face bar to
frame, and left and right bu m per brackes and remove
bu m p e r from vehicle.
3. If necessary, disassemble bu m p er by removing
bolts attaching brackets and brackes to bum per face bar.
4. If equipped with b um p e r guards (Fig. 2B-2)
remove re m a in in g nuts and bolts.
Fig. 2 B -l~ F ro n t Bumper-C, K and P Models
SECTION 2B
BUMPERS
C O N T E N TS
GENERAL DESCRIPTION
attachments are the
Rear Step Bumper - C and K M odels.................. 2B-2
Front Bumper G Series................................................ 2B-2
Rear Bumper G S e rie s................................................. 2B-2
Specifications........................................................................ 2B-3
section contains procedures
installation o f face b a r , brackets, brackes and license
plate brackets.
Installation
Assemble and install front bum per following the
removal procedure in reverse order.
REAR BUM PER-C AND K MODELS (FIG 2B-
3 )
Removal
1. Remove bolts attaching bum per to each bum per
brace. Disconnect license lamp wiring on sub urb an and
panels and pickup.
2. Remove bolts attaching bum per to frame.
3. Remove b um p e r from vehicle.
4. If necessary, replace body splash shield.
Installation
Install rear bum p er following removal procedure in
Fig. 2B-2--C, K Model Front Bum per Guards
for the removal and
I