Chevrolet 1977 light duty truck Service Manual page 138

Fig. 2D-22 -Door Hinge
3.
Foreward and R e a rw a rd -T o
ment, loosen striker bolt, shim to desired position, and
tighten bolt securely.
FR O N T DOOR ASSEMBLY
R eplacem ent
Remove the door assembly from
rem oving the hinges from the door.
DO O R H IN G E
The door check is p art o f the front door upper
hinge. The front door torque rod check holds the door in
either of two positions between full open and closed. The
make this adjust­ front door
complete unit as follows. See figure 2D-22.
Removal
1.
2.
securing front door upper hinge to cowl pillar.
the body by
a.
bolts.
b.
door, remove the door to lower hinge retaining bolts and
remove door.
Installation
1.
hinge removed.
2.
the hinge.
3.
should be made after the door is positioned in the
opening.
DOOR T R IM PANELS - CK MODELS
Door trim panel installation is illustrated in Fig.
2D-25.
DOOR V E N TILA TO R ASSEM BLY-Fig. 2D -26
Removal
NOTE: The channel between the door window
glass and door vent is removed as p art o f the vent
assembly.
1.
position.
2.
and knob from lock rod.
3.
figure 2D-27.
Fig. 2D-24--Typical Striker Bolt A djustm ent
check-hinge assembly
Loosen front fender rear bolts.
With special Tool J-22585
Remove the door to upper hinge retaining
With aid o f an assistant to support weight of
Install hinge snugly on pillar in same location as
With the aid of an assistant fasten the door to
Adjustment o f the door lock and striker plate
Regulate the door window glass to the full down
Remove clip from the window regulator handle,
Remove arm rest screws and rim panel. See
is replaced as a
remove 3 bolts