Chevrolet 1977 light duty truck Service Manual page 150

Coach models (06) and utility models (14) use
endgates o f similar, yet
procedures follow for service on each of these endgates.
E N D G A TE ASSEMBLY - (0 6 ) MODELS ONLY
Replacem ent
1. Lower endgate,
covers. See figure 2D-56.
2. Remove endgate-to-hinge bolts.
3. Remove L.H. torque rod bracket, shown in
figure 2D-57.
4. If equipped with
disconnect wiring harness.
5. Lift endgate to almost closed position
rem ove support cables.
6. Remove endgate with torque rod.
Fig. 2D-55 W eatherstrip--L.H. and R.H. Rear Door
ENDGATES (06 AND 14)
distinct design. Separate
and removed hinge access
electric powered window,
and
7. To install, reverse removal procedure.
HINGES
Replacement
If necessary to remove hinges, remove endgate as
outlined previously, and proceed as follows:
1. Remove bolts from each o f the hinge assemblies
on the underside o f the body. See figure 2D-56.
2. Remove hinge assemblies. If the hinge pins are
to be removed, note the position o f bushings so they may
be reinstalled in the same position.
3. Reverse procedure to install.
ENDGATE DISASSEMBLY
1. Remove access cover shown in figure 2D-58, to
gain access to interior components.
2. Detach remote control rods from lock assembly
by removing clips.