Chevrolet 1977 light duty truck Service Manual page 147

3. Reverse above steps for reinstallation.
REAR DOOR CHECK S TR A P
M odel 0 6
Figure 2D-53 shows the cloth check strap used for
rear doors. The door may be completely opened by
rem oving the strap pin from the bracket. The bracket
attaches to the pillar with three screws; the strap is
fastened to the door panel with two screws and an
attaching bar.
REAR D O O R -S TR IK E R AND WEDGE
A D JU S TM E N TS
Figure 2D-54 illustrates the rear door latch strikers
and door wedges. Be sure that adjustments are as shown
to insure p rop er latching o f the rear doors.
CHECK A R M -F IG . 2D-53
Replacement
1. Remove bolts securing check arm bracket to
body pillar.
2. Remove check arm access cover.
3. With one h an d supporting housing assembly
and insulator on the inside o f the door panel, remove
bolts securing housing assembly to door.
4. Remove housing, insulator and check arm.
5. To separate check arm from bracket, remove
holding pin connecting the two parts.
6. To install check arm, reverse the procedure
above.
W E A TH E R S TR IP
W eatherstrip installation is shown in figure 2D-55.
Proper installation is dependent on completely cleaning
all foreign m aterial from old installation and using a
quality cement on the new installation.