Chevrolet 1977 light duty truck Service Manual page 112

Fig. 2B-3--Rear Bum per • C, K Models
reverse order. Connect license lam p wiring on suburban
panel, and pickup models.
REAR S TE P B U M PE R C AN D K MODELS
Removal (Fig. 2B-4)
1. Disconnect license lam p wiring.
2. Remove bolts connecting bum per to brackes.
3. Remove bum per assembly.
4. Remove bolts securing bu m p er brace to fram e
and remove brace.
Installation
Install rear step bu m p e r
procedure. Connect license lam p wiring.
F R O N T B U M P E R - G MODELS
Removal Fig. 2B-5, 2B-6
Fig. 2B-4-R ear Step Bum per C and K Models
by reversing removal
1. Remove nuts securing bumpers to brackets and
braces from left and right side. Remove bumper.
2. Remove the license plate support nut and bolts.
3. If necessary to remove the braces and brackets,
remove screws securing brackets and braces to sheet
metal.
NOTE: The bum per may be removed with the
brackets and braces attached.
4. If equiped with bumper guards (Fig. 2B-6) they
may be removed from the face bar at this time.
installation
Reverse removal steps to install bumpers.
REAR BUM PER-G MODELS
Removal Fig. 2B-7, 2B-8
1. Remove nuts securing bum per to brackets and
braces and remove bumper.
2. Remove brackets and braces from vehicle.
Fig. 2B 5 -F ro n t Bum per - G Models
Fig. 2B-6-G-Models Front Bum per Guards