Chevrolet 1977 light duty truck Service Manual page 120

safety catch engagem ent and is, therefore, N O T
R E C O M M E N D E D .
Hood Rod Support - G-Series
Refer to Fig. 2C-10 for removal and installation of
hood rod support.
C A R B U R E TO R O U TS ID E AIR INLET
SNO RKELS (Fig. 2 C -1 1)
Removal
1. Raise hood and remove carburetor air duct
from air snorkel by sliding duct rearward.
2. Remove two (2) screws attaching air snorkel to
ra d ia to r support and remove from vehicle.
Fig. 2C -11-C arburetor Outside A ir Inlet Snorkels—CK
SNORKEL L O C A T IO N
L6 SNORKEL
Series
R A D IA TO R GRILLE M O LD IN G - CK MODELS
(FIG. 2C -12)
FRO NT SHEET M ETA L ASSEMBLY-CK
SERIES
Removal o f entire
including radiator involves
disconnecting rad iato r hoses and
bumper. Vehicles equipped with air conditioning a n d / o r
power steering will require special handling.
Refer to appropriate sections o f this m anual for
instructions.
Shims which are found at various locations should
be recorded to ease installation of sheet metal assembly.
Refer to Figure 2C-13 for sheet metal clearance.
Removal
1. D ra in radiator and
Disconnect oil cooler lines if so equipped.
2. Disconnect wire connectors at the dash and toe
panel and wire connector to horn and voltage regulator.
3. Disconnect battery and generator wires.
4. R em ove front
bumper.
5. Remove bolts attaching fender upper edge to
cowl door frame.
6. Remove fan shroud.
7. W orking from underneath
remove attachm ent from each fender at the hinge pillar.
front sheet metal assembly
disassembly o f mounts,
removal of front
remove radiato r hoses.
b um p e r bolts and remove
rear o f fender,