Chevrolet 1977 light duty truck Service Manual page 119

Fig. 2C-8- Hood Release Cable ■ CK Models
necessary to align hood perform procedure as outlined
under "A lignm ent" which follows.
Alignment
1.
holes in hinge is slotted to allow hood trailing edge to
move up and down.
2.
surfaces are flush.
3.
this section if necessary.
NOTE: Hood Lock Assembly to be adjusted fore
and aft until nubble (part o f Hood Lock Bolt
Support
guide (Socket). Bending nubble to accomplish this
adjustment may seriously effect lock operation and
Loosen hood hinge bolts. Note that rear bolt
Adjust hood bumpers so that hood and adjacent
Perform hood lock adjustment as outlined in
Assembly) enters center o f elongated