Chevrolet 1977 light duty truck Service Manual page 144

S T A T IO N A R Y G LA S S -R E A R DOOR
Replacem ent
1. Lower window to full down position.
2. Remove remote
regulator handle.
3. Remove screws retaining door rim pad, and
remove trim pad. See figure 2D-42.
4. Remove glass ru n channel by removing screws
retaining channel to door. See figure 2D-43.
5. Remove stationary glass.
6. Replace glass by reversing above procedure.
Glas Run C hannel Adjustm ent s
Figure 2D-44 illustrates the front ru n channel. At
the lower end, a slotted bracket provides for in-and-out
adjustment. The screw and locknut at that bracket allow
fore -a n d-aft adjustment. Together, this allows proper
control knob and window
alignment o f the glass to the rear glass run channel for
full up and down travel.
W IN D O W G LA SS-FIG . 2D 4 5
Replacement
1. Lower glass to full down position.
2. Remove remote
window regulator handle and trim pad.
3. Remove stationary glass as previously outlined.
Remove screws from rear division channel, and slide
channel rearw ard in the opening.
4. Raise glass as fa r as possible, then slide glass
until the roller is in line with the notch in the sash
channel. See figure 2D-45.
channel.
5. Tilt window outboard and move until other
roller can be removed from channel.
6. Raise window up and out.
control push botton knob,
Disengage roller from