Lcd Assembly; Removing The Lcd Assembly - Toshiba PORTEGE S100 Maintenance Manual

4.13 LCD assembly

4.13 LCD assembly

Removing the LCD assembly

To remove the LCD assembly, follow the steps below and refer to Figure 4-18.
1. Peel off the insulator and pull out the wireless LAN cable from the hole.
2. Release the wireless LAN cable from the three wireless LAN cable holders.
3. Peel off the two insulators from the LCD cable and disconnect the LCD cable from
the connector CN5500 on the system board.
4. Remove the following screws, LCD cable holder and LCD assembly.
• M2.5×6B
Insulator
PORTEGE S100 Maintenance Manual (960-508)
FLAT HEAD screw
M2.5×6B FLAT HEAD
LCD cable holder
LCD cable
CN5500
Figure 4-18 Removing the LCD assembly
4 Replacement Procedures
×2
LCD assembly
Wireless LAN
cable holder
Wireless LAN cable
Insulator
4-33