Toshiba PORTEGE S100 Maintenance Manual page 295

4.29 Fluorescent Lamp
Setting the bezel
1. Start installing the bezel in the upward direction until it stops at the top left corner.
CAUTION: (1) The GND-CU and lamp reflector on the left-hand side must not go
beyond the edges of the bezel.
(2) Be careful not to damage the cables and TAB.
(3) The bezel latches must be engaged (there are three latches).
First, fit the bezel's edge close
to the lamp. Use care not to
damage the FL cable.
Figure 4-50 Replacing 14.1 Inch TMD fluorescent lamp (XGA) (9)
PORTEGE S100 Maintenance Manual (960-508)
4 Replacement Procedure
The fold of lamp reflector must not
go beyond the bezel's edge.
The fold of GND-CU
must not go beyond
the bezel's edge.
Next, fit the bezel's edge close
to the TAB.
Engage the three latches.
4-77