Toshiba PORTEGE S100 Maintenance Manual page 252

4 Replacement Procedures
Installing the LCD assembly
To install the LCD assembly, follow the steps below and refer to Figure 4-18.
1. Install the LCD cable holder and LCD assembly and secure them with the following
screws.
• M2.5×6B
CAUTION: Apply a little LOCTITE to new screw and use it.
2. Connect the LCD cable to the connector CN5500 on the system board and secure it
with the two insulators.
3. Set the wireless LAN cable in place and secure it with the three wireless LAN cable
holders.
4. Pass the wireless LAN cable through the hole and secure it with the insulator.
4-34
FLAT HEAD screw
×2
PORTEGE S100 Maintenance Manual (960-508)
4.13 LCD assembly