Toshiba PORTEGE S100 Maintenance Manual page 291

Personal computer

Hide thumbs Also See for PORTEGE S100:

Table of Contents

4.29 Fluorescent Lamp

Removing the PCB-assembly cell

1. Remove the PCB- assembly cell from the backlight unit, as shown in Figure 4-46.

2. Completely remove the double-sided tape remaining on the reverse side of the cell.

CAUTION: (1) Remove the tape slowly not to break the cell. The cell and frame are

glued by double-sided adhesive tape (as shown in Figure 4-46).

(2) Be careful not to remove the light shielding tapes from the upper, left

and right sides of the cell.

Figure 4-46 Replacing 14.1 Inch TMD fluorescent lamp (XGA) (5)

PORTEGE S100 Maintenance Manual (960-508)

4 Replacement Procedure

Double-sided tape

Chapters

Table of Contents