Lcd Assembly/Base Assembly - Toshiba Qosmio F60 Series Maintenance Manual

Hide thumbs Also See for Qosmio F60 Series:
Table of Contents

Advertisement

エラー
スタイルが定義されていません。 エラー
!
エラー

4.19 LCD assembly/Base assembly

Removing the LCD assembly/Base assembly
To remove the LCD assembly/base assembly, follow the steps below and refer to Figure 4-28
and 4-29.
1. Peel off the acetate tapes and insulator (WLAN LOW INSIALATOR) and release
the wireless LAN antenna cables from the guides.
2. Disconnect the LCD harness and camera harness from the connectors CN5300 and
CN9550 on the system board.
3. Turn up the insulator and release the LCD harness.
4. Remove the following screws securing the LCD assembly and base assembly.
M2.56B
M2.5x6B FLAT HEAD
M2.5x6B FLAT HEAD
Drain wire
Insulator
LCD harness
Figure 4-28 Removing the LCD assembly/base assembly (1)
QOSMIO F60 Maintenance Manual (960-796)
スタイルが定義されていません。
!
FLAT HEAD screw
Camera harness
CN5300
CN9550
スタイルが定義されていません。
!
Replacement Procedures
3
M2.5x6B FLAT HEAD
Insulator
Acetate tape
Wireless LAN antenna cable
[CONFIDENTIAL]
エラー
!
4-47

Advertisement

Table of Contents
loading

Table of Contents