4.21 System board/DC-IN jack
4 Replacement Procedures
4.21 System board/DC-IN jack
Removing the System board/DC-IN jack
To remove the system board/DC-IN jack, follow the steps below and refer to Figure 4-28 to
4-30.
1. Turn over the computer and disconnect the RTC battery cable and MDC cable from
the connector CN9990 and CN3001 on the system board.
MDC cable
RTC battery cable
CN3001
CN9990
Figure 4-28 Removing the connectors
PORTEGE S100 Maintenance Manual (960-508)
4-49