Wireless Lan Board; Removing The Wireless Lan Board - Toshiba PORTEGE S100 Maintenance Manual

4 Replacement Procedures
4.7

Wireless LAN board

Removing the Wireless LAN board

To remove the wireless LAN board, make sure the computer is in boot mode and powered
off, follow the steps below and refer to Figure 4-6.
CAUTION: Do not try to remove the wireless LAN board with the computer turned on.
The computer or the wireless LAN board can be damaged. Do not touch the
connectors on the wireless LAN board module on the computer. Debris on
the connectors may cause wireless LAN board access problems.
1. Remove the Stud screw securing the wireless LAN board cover.
2. Remove the wireless LAN board cover.
3. Disconnect the wireless LAN antenna cables (black and white) from the wireless
LAN board using an antenna coaxial cable disconnector.
Wireless LAN board cover
Wireless LAN board
4-16
Latch
Figure 4-6 Removing the wireless LAN board
4.7 Wireless LAN board
Stud screw
Wireless LAN antenna
cable (black)
Latch
Wireless LAN antenna cable (white)
PORTEGE S100 Maintenance Manual (960-508)