Table of Contents
Advertisement
A.14 Appliance space limitations
• To leave adequate space around the appliance, refer to "Installation diagram".
A.15 Appliance cleaning
• Do not touch the appliance with wet hands or feet or when barefoot.
• Put the appliance in safe conditions before starting any cleaning operation.
• Respect the requirements for the various routine and extraordinary maintenance operations. Non-compliance with the
instructions can create risks for personnel.
• Do not spray water or use water jets, steam cleaner or high pressure cleaner.
A.16 Preventive Maintenance
In order to ensure the safety and performance of your equipment, it is recommended that service is undertaken by Electrolux
Professional authorised engineers every 12 months, in accordance with Electrolux Professional Service Manuals. Please contact
your local Electrolux Professional Service Centre for further details.
A.17 Parts and accessories
Use only original accessories and/or spare parts. Failure to use original accessories and/or spare parts will invalidate the original
manufacturer warranty and may render the appliance not compliant with the safety standard.
A.18 Precautions for use and maintenance
• Risks mainly of a mechanical, thermal and electrical nature exist in the appliance. Where possible the risks have been
neutralised:
– directly, by means of adequate design solutions.
– indirectly by using guards, protection and safety devices.
• Any anomalous situations are signalled on the control panel display.
• During maintenance several risks remain, as these could not be eliminated, and must be neutralised by adopting specific
measures and precautions.
• Do not carry out any checking, cleaning, repair or maintenance operations on moving parts. Workers must be informed of this
prohibition by means of clearly visible signs.
• Make sure to periodically check correct operation of all the safety devices and the insulation of electrical cables, which must be
replaced if damaged.
In case of a significant anomaly (e.g. short circuits, wires coming out of the terminal block, motor breakdowns, worn electrical cable
sheathing, etc.) the operator for normal appliance use must:
• immediately deactivate the appliance and disconnect all the supplies (electricity, gas, water).
Before carrying out any operation on the appliance, always consult the manual which gives the correct procedures and contains
important information on safety.
A.19 Appliance maintenance
• The inspection and maintenance intervals depend on the actual appliance operating conditions and ambient conditions
(presence of dust, damp, etc.), therefore precise time intervals cannot be given. In any case, careful and periodical appliance
maintenance is advisable in order to minimise service interruptions.
• It is advisable to stipulate a preventive and scheduled maintenance contract with the Customer Care Service.
• Put the appliance in safe conditions before starting any maintenance operation.
• To guarantee appliance efficiency and correct operation, periodical maintenance must be carried out according to the
instructions given in the manual.
A.20 Service
PRECAUTIONS TO BE OBSERVED BEFORE AND DURING SERVICING TO AVOID POSSIBLE EXPOSURE TO EXCESSIVE
MICROWAVE ENERGY
• Do not operate or allow the appliance to be operated with the door open.
• Make the following safety checks on all appliances to be serviced before activating the magnetron or other microwave source,
and make repairs as necessary:
1. interlock operation
2. proper door closing
3. seal and sealing surfaces (arcing, wear, and other damage)
4. damage to or loosening of hinges and latches
5. evidence of dropping or abuse
• Only original spare parts can ensure the safety standards of the appliance.
• Before turning on microwave power for any service test or inspection within the microwave generating compartments, check the
magnetron, wave guide or transmission line, and cavity for proper alignment, integrity, and connection.
• Any defective or misadjusted components in the interlock, monitor, lid seal, and microwave generation and transmission systems
shall be repaired, replaced, or adjusted by procedures described in this manual before the appliance is released to the owner.
A.21 RF interference considerations
This oven generates radio frequency signals.
12
Advertisement
Table of Contents
