Changing The Filters - Digital Projection HIGHlite Laser II 3D Series Important Information Manual

Digital Projection HIGHlite Laser II 3D Series

Changing the filters

Before changing the filters, always make sure the projector is switched off and fully
disconnected from its power supply.
When changing the filters, avoid using excessive force as this may damage the
equipment.
Remove the two screws
1.
Remove the filter cover
2.
Remove the old filter
3.
Place the new filter in the slot. Make sure the air flow arrow
4.
shown in the illustration.
5. Replace the filter cover and tighten the screws.
1
Rev C April 2017
holding the filter cover.
1
2
.
3
.
2 3
4
4
Important Information
points toward the projector, as
Page 19