Features - Omron C200H-TV Series Operation Manual

Nomenclature and Features

3-3-2 Features

Data Display
Operation Indicators
Display Patterns
Executed bank num-
ber or displayed
bank number
Name
PV (Process Displays the PV or the parameter symbol selected with the Level
Value) or Display Key (Refer to next page).
SV (Set Value) The display is as follows, according to the PV display contents.
PV (process value):
Parameter symbol:
BK (Bank Displays the bank number of the data presently being displayed.
Number) During operation, the executed bank number is displayed. (See
note)
Note Operation begins when the RUN bit of the output relay turns ON.
Name
LOOP2 Indicates whether the displayed settings relate to Loop 1 or Loop
2. Press the Loop Key and hold down for approximately 2
seconds to switch between Loop 1 and Loop 2.
OUT (Output) Turns ON when the heating output is ON
for transistor output or voltage output
types.
AT Blinks at approximately 1 second intervals
(Auto-tuning) during auto-tuning.
HB (Heater Turns ON to indicate a heater burnout
Burnout) alarm.
ALM1 (Alarm) Turns ON to indicate the temperature is in
the alarm range set with Alarm SV 1
(upper- and lower-limit alarm). Refer to the
following page.
Display Pattern 1
Process
value
Set point
Executed
bank number
or displayed
bank number
Indicator OFF: Loop 1
Indicator ON: Loop 2
Function
SV (set value) is displayed.
Setting/monitor data is displayed.
Function
Indicator OFF: Loop 1
Indicator ON: Loop 2
Display Pattern 2
Indicator OFF: Loop 1
Indicator ON: Loop 2
Section 3-3
These indicators
relate to the
currently displayed y y
loop. l
Parameter symbol
SV (Set value)
Monitored value
Execution status
23