Buffer Print; Buffer Reprint - Printronix T5000 User Manual

Buffer Print

(From page 128, page 131, page 134, page 135, page 138.)
•
Disable. The printer will print normally.
•
Enable. The printer prints the EBCDIC data and control codes received
from the host as hex values.
NOTE: Use of this parameter may alter print attributes set by the host
computer. A power cycle may be required after changing Buffer Print
from enable to disable.
The factory default is Disable.

Buffer Reprint

(From page 128, page 134.) This option is valid only when the printer is
printing in Coax SCS mode. When the ENTER key is pressed, "Buffer Reprint
Enabled" is displayed and an Intervention Required status is sent to the host.
Pressing ENTER again cancels the Buffer Reprint function and "Buffer
Reprint Disabled" is displayed.
Cancel IGP/DCU
(From page 129, page 131.)
•
Enable. Cancels all buffers when a job is put on hold from the host or
when the CANCEL key is pressed.
•
Disable. Does not cancel any internal buffer in the printer when a job is
put on hold from the host, or when the CANCEL key is pressed.
The factory default is Enable.
Change Case
(From page 129.) Specifies the font as Mono or Dual Case. This option is
available only in Coax non-SCS mode. The host will be notified of the change
when the printer is put online. Mono Case prints the same as Dual Case if the
character set is one of the following "right to left" sets: Katak, Hebrew, Old
Hebrew, and Farsi.
SCS (Systems Network Architecture Character String) Mode is controlled by
the host computer.
The options are Dual Case (the factory default) and Mono Case.
161