Save Set To Flsh; Ptx Setup Sfcc - Printronix T5000 User Manual

Save Set to Flsh

This option saves downloaded overlay set(s) to flash memory.
Del Set from RAM
This option deletes the downloaded overlay set(s) from RAM.
Ld Set at PwrUp
This option loads the downloaded overlay set from flash memory at Power
Up.
The options are Disable (the factory default) and Enable.
Alarm
•
On. An audible alarm sounds (3 beeps) when a fault occurs, such as a
paper jam.
•
Cont. Beep. A continuous audible alarm sounds when a fault occurs,
which can be stopped by pressing CLEAR.
•
Off. No audible alarm will sound.
The factory default is On.
Power-up State
•
Online. The printer powers up in the online state.
•
Offline. The printer powers up in the offline state. This selection must be
saved as a power-up configuration to be used.
The factory default is Online.

Ptx Setup SFCC

Allows you to choose the hex value of the ASCII character you wish to use as
the SFCC for the PTX SETUP command. Valid hex values are 01-FF.
The factory default value is hex 21, which corresponds to the "!" character.
Overwrite Files
This allows you to prevent files from being overwritten by disabling the
overwrite function.
The options are Enable (the factory default) and Disable.
View File List
Displays the list of files in the file system. Pressing the ↓ key displays the file
size.
PRINTER CONTROL Submenus
119