Printronix T5000 User Manual page 174

Chapter 3
Emulation Submenus
FF After Job
(From page 129.) Determines the print position after an operator-initiated local
copy (print screen function).
•
Off. Performs an automatic new line command after completing a print
buffer (unless a new line, form feed or carriage return command was the
last one executed). The printer is set to print at print position 1 of the next
line.
•
On. Performs an automatic form feed command unless a form feed was
the last one executed. The printer is set to print at print position 1 of the
first line on the next form.
The factory default is Off.
FF valid at TOF
(From page 146, page 153.) The FF valid at TOF option determines whether
the printer will perform a Form Feed when the host sends a Form Feed
command, if the printer is at the Top of Form.
•
Enable. Performs a form feed when the host sends a Form Feed
command and the printer is at the top of form.
•
Disable. Will not perform a form feed when the host sends a Form Feed
command and the printer is at the Top of Form.
The factory default is Enable.
FF Validity
(From page 129.) Determines if the position of a form feed command affects
its execution.
•
Off. Performs a form feed only if it occurs at the first print position in a line
or at Maximum Print Position +1. A form feed command at any other
position is recognized as a blank.
•
On. Allows the printer to perform a form feed command anywhere in the
data stream.
The factory default is Off.
Form Length (in.)
(From page 147, page 149, page 151, page 153, page 155.)
Form length is the number of lines that can be printed on a label. You can set
forms length in inches.
The factory default is shown in Table 2 on page 98.
174