Select Lpi; Rot. Char Size; Scalable Size - Printronix T5000 User Manual

Rot. Char Size

(From page 143.)
•
Adjusted. Rotated (clockwise/counterclockwise), expanded characters
have a different size than an unrotated character with the same size
parameters.
•
Not Adjusted. Rotated, expanded characters will be the same size as
unrotated characters with the same size parameters.
The factory default is Adjusted.

Scalable Size

(From page 141.) This option determines whether scalable characters are
sized based on normal scaling or based on the size of block characters. If the
option Block is set, then the scalable character are made to be the same size
as block characters in the old IGP-X00 printers.
The options are Normal (the factory default) and Block.
SCS Buffer Cntrl
(From page 128.) This option functions like the Early Print Complete feature
("Early Print Cmpl (Coax)" on page 170) but is for SCS only.
•
Don't Wait. The printer does not wait until the buffer is printed before
sending the print complete back to the host.
•
Wait Until Done. The printer waits until the buffer has printed before
sending the print complete back to the host.
NOTE: If set to Wait Until Done, printer speed may be reduced.
The factory default is Don't Wait.
Select Char
(From page 141.) Instructs the IGP which decimal character (0-255) to ignore
from the host.
The range is 0-255, and the factory default is 0.
Select CPI
(From page 145, page 148, page 150, page 152, page 154.) This menu item
selects the characters per inch (CPI) value.
The options are 10.0, 12.0, 13.3, 15.0, 17.1, and 20.0 CPI.
The factory default is 10.0 CPI.

Select LPI

(From page 140, page 145, page 148, page 150, page 152, page 154.) This is
the number of lines to be printed per inch. For example, at 6 lpi there is 1/6
inch from the top of one print line to the top of the next print line.
189